Contact Us

HOME

CRAMPON SELECTOR

TECH
AKA "DYNAFIT" CRAMPONS

TELEMARK CRAMPONS

FRITSCHI COMPATIBLE CRAMPONS

CRAMPON LOCKS

SKI LEASH

ADAPTER AND SHIFT PLATES

DYNAFIT / TECH CUSTOM PARTS

TOE SHIMS

Retail Outlets:

Mammoth Gear
Mammoth Lakes, CA

The Fifth Season
Mount Shasta, CA

ROAM
Nelson, BC

Alpenglow Sports
Tahoe City, CA

The Backcountry
Truckee, CA

Neptune Mountaineering
Boulder, CO

Crows Feet Commons
Bend, OR

Feathered Friends
Seattle, WA

Warning:

Ski mountaineering is an exceptionally hazardous activity which often results in severe injuries and death. Any person purchasing, or using our equipment, assumes the responsibility for seeking proper training in its use. They also assume all risk for injury, or damage, sustained while using any of our equipment. Our equipment is not to be used for any other purpose other than which it is intended. Failure to follow these warnings increase the risk of injury or death. B & D Precision is not, and shall not, be liable for direct, indirect, incidental, or other types of damages arising out of, or resulting from, the use of our products.

Always test your gear before heading to the backcountry!

Directions for Mounting our Ski/Board Leashes

Step 1

Create the Attachment Point

Dynafit Radical users should skip to step 2.

1. Cut a short segment of the attachment cord. Typically about 2-3 inches is sufficient.
Tip: Melting the ends of the cord with prevent fraying.
2. Cut a smaller segment of the vinyl tubing. Typically about 2 inches is sufficient.
3. Thread the attachment cord through the vinyl tubing leaving both ends of the attachemt cord exposed.
4. Thread the attachment cord with vinyl tubing through your preferred binding attachment point.
5. Tie the attachment cord in a loop. Recommended knots are the double fisherman's knot or a square knot.
Tip: Placing some glue on the knot will prevent the knot from working loose.

Attachment cord placed
This is how it should look with a double fisherman's knot tied.

Step 2

Attach the Fuse Link

Clip fuse link on attachment point
Using a small screwdriver hold the breakable link open as you press it onto the attachment point.

Step 3

Attach the Leash

1. Rotate the breakable link around so the attachment point is on the other side of the fuse link.
2. Remove the key ring from the leash and slip on the long rubber sleeve.
Tip: It is easier to slide the rubber sleeve over the end of the leash if you wet the inside of the rubber sleeve.

Clip leash on fuse link
3. Using a small screwdriver hold the fuse link open as you press the leash into the fuse link.
4. Slide the rubber sleeve over the fuse link.

Close-up of Attachment

This is how the finished product should look on a Dynafit Radical.

Completed setup

B & D Precision © 2013, Page Last Updated 11/15/2013